How To Secure A Bathtub

Introduction

Securing a bathtub is essential for safety reasons. A bathtub that is not properly secured can cause accidents such as slips and falls. In this article, we will guide you on how to secure a bathtub.

Materials Needed

The following materials are needed:

• Bathtub
• Bathtub anchor kit
• Screwdriver
• Adjustable wrench
• Plumber's putty

Step by Step Guide

Step 1: Turn Off Water Supply

Before securing the bathtub, turn off the water supply to avoid any leaks. Locate the water shut-off valve near the bathtub and turn it clockwise until it is fully closed.

Step 2: Install Bathtub Anchors

Use the bathtub anchor kit to install the anchors on the floor. Place the anchors in the desired location and use a screwdriver to secure them in place. It is important to ensure that the anchors are level and secure.

Step 3: Position the Bathtub

Position the bathtub on the anchors and align it with the drain. Use an adjustable wrench to tighten the drain and overflow connections. Ensure that the bathtub is level and stable.

Step 4: Seal the Edges

Use plumber's putty to seal the edges of the bathtub. Apply a thin layer of putty around the edges of the bathtub and press it firmly in place. Wipe away any excess putty with a damp cloth.

Step 5: Turn on Water Supply

Turn on the water supply and check for leaks. If there are any leaks, tighten the connections with an adjustable wrench. Once there are no leaks, test the bathtub to ensure it is secure.

Conclusion

Securing a bathtub is an important safety measure that should not be overlooked. Follow the above steps to ensure that your bathtub is properly secured and safe to use.